Wednesday 21 December 2016

AV Injection | Vehicle Barriers

Vehicle Barriers

Av Injection was approached to look at a solution in Plastic Injection Moulding using a raw material to make a vehicle barrier.
The material used has to be able to be Injection Moulded and at the same time be able to meet the customer high specification. The application is a barrier to stop vehicles driving into restricted areas. Test was carried out and can be seen on You Tube upon request.
The design of the mould was very important and the raw material were put to the test to withstand the extreme pressures and impact tests.
AV Injection were able to solve all the aspects of this project in finding the correct raw material, and getting the design of the mould tool to be able to produce a high quality part to meet the extreme impact forces needed.
To add to the service AV Injection were able to make the product with a very high standard outer surface finish.
For further information on any of our case studies or if you would like to discuss your project please Contact Us.

No comments:

Post a Comment